X67DO1332

X67DO1332 is a B & R Automation module in the X67 Analog Input Output Modules series. It provides eight digital outputs for controlling connected devices. The outputs use current-sourcing FET technology, which supplies current to each connected load when switched on. The I/O operates at a nominal 24 VDC, while each output supports a nominal current of 2 A. The total nominal current is 8 A across the module. Actuator supply power is limited to 12 W, internal I/O power consumption is 2 W, and the X2X Link requires 0.75 W for bus operation.

The outputs support resistive-load switching at up to 100 Hz. The switch-on delay is less than 250 µs, and the switch-off delay is less than 270 µs, indicating the time required for each output to change state. Residual voltage is less than 0.5 V at a 2 A load, limiting the voltage drop across an active output. Off-state leakage is 5 µA, indicating the small current that may pass while an output is disabled. Peak short-circuit current remains below 21 A to characterize output behavior during a fault. The 50 VDC inductive braking voltage controls voltage generated when inductive loads are switched off. An IP67 protection rating provides dust-tight protection and resistance to temporary water immersion when the module is properly installed.